Makita GV7000C User Manual

9
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Rubber pad
• Abrasive discs
• Lock nut
• Lock nut wrench 28
• Wrench 17
1. Limit mark
1
001145
1. Brush holder cap
2. Screwdriver
2
1
003423

Makita GV7000C Specifications

General

Product color	Black, Turquoise
Type of sander	Orbital sander
Adjustable speed	Yes
Idle speed (max)	4700 RPM
Idle speed (min)	2500 RPM
Power	- W
Power source	AC

Weight and Dimensions

Depth	210 mm
Weight	2000 g
Sanding disc diameter	180 mm
Sanding plate size (WxD)	- mm