7
Indicator lamp
The green power-ON indicator lamp lights up when the tool is
plugged. The indicator lamp is lit but the tool does not start
even if the tool is switched on, the carbon brushes may be
worn out, or the electric circuit or the motor may be defective.
If the indicator lamp does not light up and the tool does not
start, the ON/OFF switch or the mains cord may be defective.
The red service indicator lamp lights up when the carbon
brushes are nearly worn out to indicate that the tool needs
servicing. After approx. 8 hours of use, the motor will auto-
matically be shut off.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Side grip (auxiliary handle)
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip by
turning it counterclockwise, swing it to the desired position
and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount of
bit grease (about 0.5 -1 g;.). This chuck lubrication assures
smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing the
bit.
1. Power-ON indicator lamp ( green)
2. Service indicator lamp ( red )
1
2
004482
1. Side grip
1
004483
1. Bit shank
2. Bit grease
2
1
003150
To Next Page
Loading...
Need help?
General
