Makita HR4001C User Manual

7
Hammering only
FOR MODEL HR4001C AND HR4010C
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the symbol. Use a bull
point, cold chisel, scaling chisel, etc.
For long time hammering (FOR MODELS HR4001C AND HR4010C ONLY)
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the symbol. Use a bull
point, cold chisel, scaling chisel, etc.
CAUTION:
• When using the tool in the symbol mode, the switch trigger does not
work and only the slide switch works.
FOR MODEL HR4011C
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the symbol. Use a bull
point, cold chisel, scaling chisel, etc.
CAUTION:
• Do not rotate the change lever when the tool is running under load. The
tool will be damaged.
• To avoid rapid wear on the mode change mechanism, be sure that the
change lever is always positively located in one of the two or three action
mode positions.
Torque limiter
The torque limiter will actuate when a certain torque level is reached. The
motor will disengage from the output shaft. When this happens, the bit will stop
turning.
CAUTION:
• As soon as the torque limiter actuates, switch off the tool immediately.
This will help prevent premature wear of the tool.
1. Change lever
2. Pointer
3. Lock button
1
HR4001C /HR4010C
2
3
006311
1. Change lever
2. Pointer
3. Lock button
1
HR4001C
HR4010C
2
3
006313
1. Change lever
2. Pointer
3. Lock button
1
2
3
HR4011C
006312

Makita HR4001C Specifications

General

Cord length	4 m
Input power	1100 W
Output power	1200 W
Power source	AC
Impact rate	2750 bpm
Rated speed (max)	480 RPM
Impact energy (max)	6.8 J
Sound pressure level	92 dB
Drilling diameter in concrete (max)	40 mm

Weight and Dimensions

Depth	106 mm
Width	468 mm
Height	261 mm
Weight	6300 g