Makita LB1200F User Manual

12
Cutting speed adjustment
1. Open the lower cover.
2. Slacken driving belt by turning the knob clockwise.
3. Put driving belt on the required pulley of the driving wheel (lower band saw
wheel) and the corresponding motor pulley-note label inside the lower cover.
CAUTION:
The driving belt must run either on both front or both rear pulleys. Never have the V-
belt run diagonally.
Setting knob for belt tension
With the setting knob the belt tension is corrected if necessary:
- turning the setting knob clockwise reduces the driving belt tension.
- turning the setting knob counter-clockwise increases the driving belt tension.
Tighten the driving belt again by turning the knob counter-clockwise (half-way
between the pulleys the driving belt should flex approx. 10 mm).
Close the lower cover.
Lower band saw wheel
8.3/6.7 m/s
(500/400 m/min)
16.7/13.3 m/s
(1,000/800 m/min)
Motor pulley
Knob
Lower cover
Motor pulley
Pulley of the driving
wheel
approx. 10 mm
Driving belt

Makita LB1200F Specifications

General

Purpose	-
Cutting speed	13.3 m/s
Product color	Black, Blue
Beveling table	Yes
Number of speeds	2
Table bevel angle	-2 - 45 °
Idle speed (max)	- RPM
Blade length	2240 mm
Input power	900 W
Power source	AC
AC input voltage	230 V

Weight and Dimensions

Depth	615 mm
Width	775 mm
Height	1600 mm
Weight	81200 g
Table depth	440 mm
Table width	560 mm