Makita LB1200F User Manual

17
Operation
Danger:
To reduce the risk of personal injury as much as possible, the following safety
recommendations should be observed when operating the saw.
CAUTION:
• Do not touch the saw blade when cutting.
• During saw operation, wear safety glasses, but do not wear gloves.
• Cut only one work piece at a time.
• Always hold the work piece down on the table.
• Do not jam any work pieces.
• Do not try to slow the band saw blade down or stop it by pushing the work piece
against the saw blade from the side.
• When straight cutting against the fence use a push stick.
• If the type of work requires, use the following:
- pushing stick — if distance rip fence - band saw blade  150 mm;
- work support — for long stock, which would otherwise fall off the table on
completion of the cut;
- dust collector;
- when cutting round stock, firmly secure material as shown in diagram.
- a suitable guide for firm support when cutting thin stock layed on edge.
- gloves for handling the saw band and rough material.
• Before starting work, check to see that the following are in proper working order:
- band saw blade;
- upper and lower blade guard.
• Replace damaged parts immediately.
• Assume correct work position (the band saw blade’s teeth must point towards the
operator).
Lock lever

Makita LB1200F Specifications

General

Purpose	-
Cutting speed	13.3 m/s
Product color	Black, Blue
Beveling table	Yes
Number of speeds	2
Table bevel angle	-2 - 45 °
Idle speed (max)	- RPM
Blade length	2240 mm
Input power	900 W
Power source	AC
AC input voltage	230 V

Weight and Dimensions

Depth	615 mm
Width	775 mm
Height	1600 mm
Weight	81200 g
Table depth	440 mm
Table width	560 mm