To Next Page

To Previous Page

9 ENGLISH

ASSEMBLY

WARNING: Always be sure that all the battery

cartridges are removed before carrying out any

work on the machine. Failure to remove all the bat-

tery cartridges may result in serious personal injury

from accidental start-up.

WARNING: Never start the mower unless it is

completely assembled. Operation of the machine

in a partially assembled state may result in serious

personal injury from accidental start-up.

Installing the handle

NOTICE: When installing the handles, be careful

not to pinch the cord between the handles. If the

cord is damaged, the mower switch may not work.

1. Align the hole in the lower handle with the hole

in the upper handle, then insert the bolt from outside,

and then tighten the thumb nut from inside. Perform the

same procedure on the other side.

1 232

Fig.1

► 1. Bolt 2. Thumb nut 3. Lower handle 4. Upper

handle

2. Turn the knob 90° while pulling the knob on the

lower handle to release the locking pin. Perform the

same procedure on the other side. Raise the handle,

and then turn the knob on both sides 90°. Make sure

that the knobs are securely xed.

Fig.2

► 1. Knob

NOTE: Supporting the handle makes it easier to

release the locking pin when pulling the knob.

NOTE: When turning the knob, be careful not to get

the cord caught in the knob.

Fig.3

► 1. Knob

Makita LM001G User Manual

Questions and Answers: