Makita LW1401 User Manual

9 ENGLISH
1
►1. Spacer block
When cutting workpieces over 85 mm wide at an angle,
attach a straight piece of wood (spacer) over 190 mm
long x 45 mm wide to the guide plate as shown in the
gure.Attachthisspacerwithscrewsthroughtheholes
in the guide plate. Make sure that the cut-off wheel does
not contact the spacer when the tool head is depressed.
1
2
3
4
►1. Guide plate 2. Spacer block (over 190 mm long
x45 mm wide) 3. Workpiece (over 85 mm wide)
4. Vise plate
When the cut-off wheel has worn down, raise the cutting
position by putting a spacer block which is slightly nar-
rowerthantheworkpieceasshowninthegure.This
will help you to utilize the wheel economically.
1 2 3
4
►1. Vise plate 2. Workpiece diameter 3. Guide plate
4. Spacer block width
Long workpieces must be supported by blocks on
either side so that it will be level with the base top. Use
non-ammablematerialforsupportingblocks.
1
►1. Supporting block
Carrying tool
Fold down the tool head and lock it. Hold the handle
when carrying.
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.

Makita LW1401 Specifications

General

Brand	Makita
Model	LW1401
Category	Saw
Language	English