Makita MLS100 User Manual

10 ENGLISH
1
► 1. Hex bolt
Press the shaft lock to lock the spindle and use the
wrench to loosen the hex bolt clockwise. Then remove
the hex bolt, outer ange and blade.
1
2
► 1. Hex bolt 2. Wrench
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the sur-
face of the blade matches the direction of the arrow on
the blade case.
1
2
3
4
► 1. Blade case 2. Arrow 3. Arrow 4. Saw blade
Install the outer ange and hex bolt, and then use the
wrench to tighten the hex bolt (left-handed) securely
counterclockwise while pressing the shaft lock.
12 4
3
5
► 1. Hex bolt 2. Outer ange 3. Saw blade 4. Inner
ange 5. Spindle
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Lower the handle to make sure that
the blade guard moves properly. Make sure shaft lock
has released spindle before making cut.
Sub-fence
Country specic
WARNING: When performing left bevel cuts,
ip the sub-fence outward. Otherwise, it may con-
tact the blade or a part of the tool, and may result in
serious injury to the operator.
1
► 1. Sub-fence
This tool is equipped with the sub-fence. Usually posi-
tion the sub-fence inside. However, when performing
left bevel cuts, ip it outward.

Makita MLS100 Specifications

General

Input power	1500 W
Power source	AC
Blade diameter	255 mm
Idle speed (max)	4200 RPM

Weight and Dimensions

Weight	14700 g