Makita SP6000 User Manual

12
1
007667
1
007668
NOTE:
• Adjusting for accuracy of 22.5° , 48° and -1° cut
cannot be performed.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
007676
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Saw blades
• Guide rail
• Rip fence (Guide rule)
• Miter gauge
• Clamp
• Hex wrench
• Sheet set for guide rail
• Rubber sheet set for guide rail
• Position sheet set for guide rail
1. Screwdriver
2. Brush holder
cap
1. Limit mark
1. Adjusting screw
for 45 ﾟ
1. Adjusting screw
for 90 ﾟ

Makita SP6000 Specifications

General

Soft start	Yes
Product color	Black, Blue
Power protection features	Overload
Diamond disc	-
Vibration emission	2.5 m/s²
Cross stop tilt angle range	-1 - 48 °
Idle speed (max)	6400 RPM
Idle speed (min)	2000 RPM
Blade diameter (max)	165 mm
Blade diameter (min)	160 mm
Cutting depth (45º)	40 mm
Cutting depth (90º)	56 mm
Sound pressure level	92 dB
Input power	1300 W
Cable length	4 m
AC input voltage	230 V

Weight and Dimensions

Depth	346 mm
Width	225 mm
Height	252 mm
Weight	4400 g