Makita XCU04PT1 User Manual

2 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: XCU03 XCU04
Overall length (without guide bar) 443 mm
(17-1/2″)
Rated voltage D.C. 36 V
Net weight 4.6 - 5.5 kg
(10.2 - 12.1 lbs)
Standard guide bar length 350 mm
(14″)
400 mm
(16″)
Recommended guide bar
length
with 90PX, 91PX 300 - 400 mm
(12 - 16″)
with 25AP 250 mm
(10″)
Applicable saw chain type
(refer to the table below)
90PX
91PX
25AP
Standard sprocket Number of teeth 6
*1
Pitch 3/8″
Chain speed 0 - 20 m/s
(0 - 1,200 m/min)
(0 - 3,940 ft/min)
Chain oil tank volume 200 cm
3
•
*1
When using 25AP saw chain, use with Sprocket 9 (optional accessory).
• Due to our continuing program of research and development, the specications herein are subject to change
without notice.
• Specications may di󰀨er from country to country.
• The weight may di󰀨er depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF / DC18SH
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or re.
Recommended cord connected power source
Battery adapter BAP182
Portable power pack PDC01 / PDC1200
• The cord connected power source(s) listed above may not be available depending on your region of residence.
• Before using the cord connected power source, read instruction and cautionary markings on them.

Makita XCU04PT1 Specifications

General

Brand	Makita
Model	XCU04PT1
Category	Chainsaw
Language	English