19
ENGLISH
Replacing the sprocket
CAUTION: A worn sprocket will dam-
age a new saw chain. Have the sprocket
replaced in this case.
Before tting a new saw chain, check the condi-
tion of the sprocket.
1
2
► 1. Sprocket 2. Areas to be worn out
Always t a new locking ring when replacing the
sprocket.
1
2
► 1. Locking ring 2. Sprocket
NOTICE: Make sure that the sprocket is
installed as shown in the gure.
Storing the tool
1. Clean the tool before storing. Remove any
chips and sawdust from the tool after removing
the sprocket cover.
2. After cleaning the tool, run it under no load
to lubricate the saw chain and guide bar.
3. Cover the guide bar with the guide bar
cover.
4. Empty the oil tank.
To Next Page
Loading...
Need help?
General
