Throttle lever control system
68
Shielded lines/cables for the Marex OSII (MPC) throttle lever control system
Shielded CAN bus wires must be used between the Marex OSII (MPC) throttle lever control and the throttle
levers. These shielded wires are necessary to avoid the affects of electromagnetic radiation (e.g. mobile
phones) to the throttle lever control. Improper wiring could result in fluctuations in the speed set by the
throttle levers.
1
2
2
Caution:
To preclude confusing with other CAN bus cables, please note the metal guide À of the union nut
and the green marking Á at the cable ends.
CAN bus connection lines and termination resistors
MAN Part Number Bosch Rexroth number Designation
51.25449−0056 R419800177 M12 cable 2m long
51.25449−0057 R419800178 M12 cable 5m long
51.25449−0052 R419800179 M12 cable 10m long
51.25449−0053 R419800180 M12 cable 15m long
51.25449−0054 R419800181 M12 cable 20m long
51.25449−0055 R419800182 M12 cable 30m long
51.25435−0174 8941054264 M12 terminating plug 120 Ω male
51.25432−0053 8941054274 M12 terminating plug 120 Ω female
To Next Page
Loading...
Need help?
General
