The anchor light is a white light located on the top of your bimini, sport
arch, or tower. Use this light while your boat is anchored on the water
after dark so that other boaters can see your boat. It must also be used
while the boat is underway
after dark, with the three
position Anchor/ Navigation
switch set to the navigation
position. While at rest, with the
anchor down, set the switch to
the anchor setting. Once
underway again, return the
switch to the navigation
position.
Note: It is important to
know and follow all laws
related to the use of the
anchor light.
Switches
Electrical switches control the supply of power to your boat’s
components. Switches may be two-position (either on or off), or three-
position (in which the center position is off). On a three-position switch,
the switch position determines which components are activated.
Some switches have an adjacent push-button reset breaker, and others
have automotive-style fuses mounted inside the helm. These breakers
and fuses protect the electrical components from damage by power
surges.
Note: If you reset a breaker and it immediately trips again, there may
be an electrical problem that needs attention. Do not attempt a
second reset. Consult your Manitou dealer for more information.
If you replace a breaker, replace it with the same size breaker. Note, too,
that there are other switches that are not on the dash, such as the switches
for the bilge and galley pumps. These have a pop-breaker near their
location.
To Next Page
Loading...
Need help?
General
