40,000 lb
Pick & Carry
up to 2.5 mph
Boom Centered
over Front
Main boom length in feet
#9006
Feet
42 57 72 86
NOTES:
1. Capacities are in pounds and do not exceed
75% of tipping loads as determined by test in
accordance with SAE J-765.
2. Capacities are applicable to machines
equipped with 33.25x29 (38 ply) bias ply tires,
at 85 psi cold inflation pressure.
3. Capacities appearing above the bold line are
based on structural strength and tipping
should not be relied upon as a capacity
limitation.
4. Capacities are applicable only with machine
on firm level surface.
5. On rubber lifting with boom extension not
permitted.
6. Axle lockouts must be functioning when
lifting on rubber.
7. For pick and carry operation, boom must be
centered over front of machine, mechanical
swing lock engaged and load restrained
from swinging. When handling loads in the
structural range with capacities close to
maximum ratings, travel should be reduced
to creep speeds.
8. All lifting depends on proper tire inflation,
capacity and condition. Capacities must be
reduced for lower tire inflation pressures. See
lifting capacity chart for tire used. Damaged
tires are hazardous to safe operation of
crane.
9. Creep – not over 200 ft of movement in any
30 minute period and not exceeding 1 mph.
To Next Page
Loading...
Need help?
General
