Part Number 040005626 5/17 33
Step 9 Mix a solution of sanitizer and warm water.
Step 10 Use half of the sanitizer/water solution to
sanitize all removed components. Use a spray bottle
to liberally apply the solution to all surfaces of the
removed parts or soak the removed parts in the
sanitizer/water solution. Do not rinse parts after
sanitizing.
Step 11 Use half of the sanitizer/water solution to
sanitize all foodzone surfaces of the ice machine and
bin. Use a spray bottle to liberally apply the solution.
When sanitizing, pay particular attention to the
following areas:
• Evaporator plastic parts - including top, bottom and
sides
• Bin bottom, sides and top
Do not rinse the sanitized areas.
Step 12 Replace all removed components.
Step 13 Wait 25 minutes.
Step 14 Reapply power and water to the ice machine
and place the toggle switch in the ice position.
Step 15 Water will flow through the water dump valve
and down the drain. Wait until the water trough refills,
then add the proper amount of ice machine sanitizer to
the water trough.
Wait until the sanitize cycle is complete (approximately
24 minutes) then place the toggle switch in the ice
position to start ice making.
Solution Type Water Mixed With
Sanitizer 3 gal. (12 l) 2 oz (60 ml) sanitizer
Model Amount of Sanitizer
M0420 M0500 M0700
M1000
3 ounces (90 ml)
M1350 6 ounces (180 ml)
To Next Page
Loading...
Need help?
General