34 Part Number 040005626 5/17
REMOVE PARTS FOR CLEANING
1. Remove the water curtain
• Gently flex the curtain in the center and
remove it from the right side.
• Slide the left pin out.
2. Remove the water trough
• Depress tabs on right and left side of the water
trough.
• Allow front of water trough to drop as you pull
forward to disengage the rear pins.
3. Remove the ice thickness and harvest float
switches
• Pull the float switch straight down to
disengage.
• Lower the float switch until the wiring
connector is visible.
• Disconnect the wire lead from the float switch.
• Remove the float switch from the ice machine.
4. Remove the water distribution tube
NOTE: Distribution tube thumbscrews are retained to
prevent loss. Loosen thumbscrews but do not pull
thumbscrews out of distribution tube.
• Loosen the two outer screws (do not remove
screws completely they are retained to prevent
loss) and pull forward on the distribution tube
to release from slip joint.
• Disassemble distribution tube by loosening the
two (2) middle thumbscrews and dividing the
distribution tube into two pieces.
• Proceed to page 32 Step 6.
Disconnect electric power to the ice machine
at the electric switch box before proceeding.
To Next Page
Loading...
Need help?
General