24 Part Number 000001590 Rev03 11/19
Maintenance Section 4
Removal of Parts for Cleaning/Sanitizing
1. Turn off the electrical and water supply to the ice
machine.
n
Warning
Disconnect electric power to the ice machine before
proceeding with any of the following procedures.
2. Remove all ice from the bin.
3. Remove the components that must be cleaned
and sanitized. See the following pages for removal
procedures for these parts.
n
Warning
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or Sanitizer.
4. Soak the removed part(s) in a properly mixed solution of
cleaner.
Solution Type Water Mixed With
Cleaner 1 gal. (4 l) 8 oz (240 ml) cleaner
Sanitizer 2 gal. (8 l) 1 oz (30 ml) sanitizer
5. The cleaner will foam; once the foaming stops use a soft-
bristle nylon brush, sponge or cloth (NOT a wire brush)
to carefully clean the parts.
,
Caution
Do not mix Cleaner and Sanitizer solutions together. It
is a violation of Federal law to use these solutions in a
manner inconsistent with their labeling.
,
Caution
Do not immerse the water pump motor in the cleaning or
sanitizing solution.
6. Thoroughly rinse all the parts with clear water.
7. Soak the removed parts in a properly mixed solution of
sanitizer for 5 minutes.
8. Use a soft-bristle nylon brush, sponge or cloth (NOT a
wire brush) to carefully sanitize the parts.
9. Use the sanitizing solution and a sponge or cloth to
sanitize (wipe) the interior of the ice machine and bin.
10. Rinsing is not required when using Manitowoc Sanitizer.
11. Install the removed parts.
12. Turn on the water and electrical supply
TOP COVER
1. Disconnect power to the ice machine.
2. Remove two back screws.
3. Slide top cover backward slightly and lift cover off.
1
2
To Next Page
Loading...
Need help?
General