76 Part Number 000014797 Rev02 05/18
Operational Checks
ICE THICKNESS CHECK
After a harvest cycle, inspect the ice cubes in the ice
storage bin. The ice bridge connects the ice cubes and
must be set to maintain an ice bridge thickness of 1/8"
(3.2 mm). To adjust the thickness of the bridge refer to ice
thickness adjustment.
ICE THICKNESS ADJUSTMENT
The ice thickness can be adjusted to three levels.
1. Pull forward on the bottom of the bracket until clear
of the tab.
2. Slide the bracket over the desired tab and release.
• The center position is the normal factory setting.
• To increase bridge thickness, raise the water level.
• To decrease bridge thickness, lower the water
level.
THICKER
BRIDGE
THINNER
BRIDGE
FACTORY
DEFAULT
To Next Page
Loading...
Need help?
General