3-4 Part Number: 040003628 Rev. 01 01/14/18
Operation Section 3
SPRAY BAR
The spray bar supplies water to the individual ice-
making cups. Water from the water pump sprays
through the nozzles, located on the upper portion of the
tubes.
1. Grasp one end of the spray bar, lift up and remove
from seat formed in water trough.
2. Remove both plastic clips on water inlet tubing by
grasping both ears on clip and separating.
3. Apply food grade lubricant to ease re-assembly of
spray bar components when necessary.
4. To re-install spray bar, position water inlet tubing on
inlet ports, and squeeze clips until tight.
5. Reposition assembly on water trough seat.
Nozzles and inserts can be removed for cleaning by
unscrewing nozzles. Inserts are located inside the spray
bar ports. The spray bar also disassembles for easy
cleaning.
SUMP DRAIN OVERFLOW TUBE
The sump drain overflow tube is located in the
evaporator water sump.
1. Remove shutters and ice chute.
2. Lift spray bar or disconnect and remove for easiest
access.
3. Pull up on overflow tube to remove.
4. To replace plug, insert in hole and push with force to
make a tight seal.
Overflow Tube
To Next Page
Loading...
Need help?
General