0. Introduction - Specifications
4 Workshop Service Manual for CENTORA 7280-7282 Combine Range - EN_D3111800M2
0.2 General specifications
Cutting table
Quick-attach type, can be attached and removed directly on the ground
Power take-off with transmission shaft
Unit CENTORA
7280/7282
Cutting height PowerFlow cm -40 to +148
Knife speed strokes/
min.
1138
Hydraulically balanced by pressure accumulators yes
Electrohydraulic cutting height presetting yes
Reel Unit CENTORA
7280/7282
Electrohydraulic reel drive rpm 0-50
Peripheral speed km/h 0-9.1
Electrohydraulic reel control up/down and fore/aft yes
Threshing cylinder Unit CENTORA
7280/7282
Speed, normal rpm 400-1120
Speed, reduced rpm 307-945
Width cm 168
Number of rasp bars units 8
Diameter cm 60
Weight kg 318
Electrohydraulic speed adjustment yes
Peripheral speed m/sec. 12.3-36.1
Peripheral speed, reduced m/sec. 9.6-29.7
Concave Unit CENTORA
7280/7282
Concave area cm² 10600
Number of rub bars units 13
Concave wires, self-cleaning, spring steel mm Ø 3.5
Concave wrap degrees 117
Concave adjustable from operator seat yes
To Next Page
Loading...
Need help?
General