Warning Plates and Labels
Read and note ALL warning plates and labels from
bow to stern, including those that are installed inside the
engine compartment, lockers and under seating. YOU
MUST READ AND ADHERE TO ALL CAUTIONS AND
WARNINGS IN AND ON YOUR BOAT!
Operator’s Responsibilities
• Ensure the boat is in top operating condition and there are no hazards that impede your moving about the boat.
• Ensure the bilge is clean prior to starting.
• File a oat plan, as described below, with a relative or friend.
• Have a complete knowledge of the operation and handling characteristics of your boat.
• Ensure that the boat is not loaded above the maximum capacity and that the load is properly distributed.
• Have familiarity with your starting location and your goal, and the waterways between.
• Maintain a safe speed at all times to avoid collisions.
• Keep an eye out for changing weather conditions and respond accordingly.
• Know and practice the navigational rules. Know and obey all federal and state regulations and operate the boat
properly around all waterway markers.
• Maintain a clear, unobstructed view at all times, especially forward. Scan the water and avoid tunnel vision. Many
boating collisions are caused by inattention.
Float Plan
A “oat plan” is a written record indicating the planned destination and approximate length of time for the outing.
Sample forms are available at the Coast Guard’s website. One should be completed and left with a relative or friend prior
to each trip. In case of an emergency or failure to return within a reasonable period of time, pertinent information will be
available to assist local marine police or the Coast Guard in determining whether a search should be performed. Be sure
to notify the oat plan holder upon return.
MasterCraft 2012 Owners Manual • Safety Knowledge • Page 1-8
To Next Page
Loading...
Need help?
General
