135
134
9.22 CONSOLE PARTS REPLACEMENT - CONTINUED
CHAPTER 9: PART REPLACEMENT GUIDE
7. Remove the TV tuner (Figure G).
8. Remove the touch switch wire fixing plate (Figure H).
9. Remove the touch switch board (Figure I).
10. Remove the touch panel wire from switch board (Figure J).
11. Remove the panel inverter (Figure K).
12. Remove the panel plate (Figure L).
13. Reverse Steps 1-12 to install new console parts.
FIGURE JFIGURE I
FIGURE HFIGURE G
FIGURE LFIGURE K
9.23 TESTING THE CLIMB MILL
CHAPTER 9: PART REPLACEMENT GUIDE
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console. Also set the Machine Type (ENTER, 3, 0, 0, 2,
ENTER) and verify that the Date and Time are correct (See Section 7.2). note: If he Machine Type setting has been changed, the unit power
should be reset. Cycle the power switch.
2) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER). Then edit Club ID on the Asset Management and Root Path on the Virtual Active
depending on whether the club has these functions.
3) Program the TV channels in Section 10.5.
4) Press the green GO key and begin using the machine. Stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
5) Grasp the hand grips to check for proper heart rate response.
6) Press the LEVEL UP and DOWN keys on the console to make sure resistance is fully functional.
7) Try stepping off the unit to make sure the proximity sensor is fully functional. Also test the STOP key on the grips and the Control Zone for
function.
To Next Page
Loading...
Need help?
General
