Matrix ENDURANCE CLIMBMILL User Manual

6
ENGLISH
Levelers
To attach end caps, slide (1) over
(2) and then slide (3) into (4).
1
2
3
4
ASSEMBLY
ASSEMBLY COMPLETE
Levelers
4
PERFORMANCE ONLY
1. Connect the wires from the
frame to the Base Step.
2. Lift the Control Zone over the
caster wheels. Push down firmly
on both sides until it seats firmly.
3. Slide the Sweat Collector Tray
under the ClimbMill, latching
the handle to the base.
4
ENDURANCE ONLY
LOCATION OF THE UNIT
Place the unit on a level and stable surface away from direct sunlight. The intense UV light can
cause discoloration on the plastics. Locate your unit in an area with cool temperatures and low
humidity. Please leave a clear zone behind the unit that is at least 24” (610 mm). This zone must
be clear of any obstruction and provide the user a clear exit path from the machine. Do not place
the unit in any area that will block any vent or air openings. The unit should not be located in a
garage, covered patio, near water or outdoors.
HEIGHT REQUIREMENTS
The ClimbMill adds 30 - 38” (76 - 96.5cm) to a users height. For example, a 6’ (183cm) tall user will
be 8’6” - 9’ 2” (259.5 - 279.5cm) off the floor.
BEFORE YOU BEGIN
TRAINING AREA
3.05 M
(10 ft)
1.65 M
(65”)
0.85 M
(33.5”)
FREE AREA
3.05 M
(10 ft)
2.26 M
(89”)
0.85 M
(33.5”)

Matrix ENDURANCE CLIMBMILL Specifications

General

Brand	Matrix
Model	ENDURANCE CLIMBMILL
Category	Fitness Equipment
Language	English