12
!WARNING! Regular maintenance must be performed on the KRANKcycle™
for optimal performance and longevity. Please read and follow all instructions
below. If the cycle is not maintained as described, components may wear
excessively and the cycle may become damaged. Improper maintenance will
void the warranty terms. If you have questions about maintenance, contact
your local distributor or go to www.matrixfitness.com.
Note: Many maintenance procedures require lubricant (ex. brake pad,
chains, and sprockets). MATRIX recommends 3-IN-ONE oil.
6.1 DAILY MAINTENANCE
1. Make sure that the KRANKcycle™ is level. If it rocks on your floor, turn
the leveling feet underneath the front stabilizer until the rocking motion is
eliminated (see page 11).
2. After each use, the cycle should be disinfected and cleaned to maintain
a hygienic environment. Clean cycle with mild soap and water or other
non-ammonia based all purpose cleaners. Apply cleaner to lint free cloth
and wipe crank handles, adjustment knobs and levers, base plate and the
seat. Do not pour liquids directly onto the equipment. Maintain a clean
environment around the cycle, free of dust and dirt.
6.2 WEEKLY MAINTENANCE
1. Apply a small amount of mild soap and water or other non-ammonia
based all purpose cleaner to a lint free cloth and thoroughly clean the
frame, crank handles, adjustment knobs and levers, seat, flywheel,
baseplate and plastic covers.
2. Check regular functions of cycle and consult the TROUBLESHOOTING
GUIDE (see page 13) if any problems exist.
6.3 MONTHLY MAINTENANCE
1. For optimal performance of the resistance system the following steps
should be taken:
a. Remove lower inside plastic cover by removing 6 socket head cap screws
with a 3mm ALLEN KEY WRENCH.
5.1 JOHNNY G KRANKcycle™ by MATRIX
CHAPTER 6: P
To Next Page
Loading...
Need help?
General
