CHAPTER 4: Rower parts and assembly Guides
4.3 ASSEMBLY STEPS
Mount the seat to the seat bracket with 4 screws (D09) and washers (D10).
Slide the seat assembly onto the aluminum rail.
Attach the seat stop bumper to the aluminum rail using the screw (F07) and
washer (F19).
1)
2)
3)
STEP 3
Place the rear foot position plate F04 inside the aluminum rail close to the
edge. Attach the rear foot to the aluminum rail and align the four holes
of the aluminum rail with the four holes of the rear foot. Thread the bolts
(H04) with spring washers (H05) through the rear foot into the rear foot
position plate and tighten them.
Press the seat rail end cap into the aluminum rail, and use two screws
(F20) to fix the cap.
1)
2)
To Next Page
Loading...
Need help?
General
