Matrix t3x-03 User Manual

22
8.5 0140 / 01A0 ERROR TROUBLESHOOTING
ERROR MESSAGE 0140 / 01A0
1) CAUSE:
a. Incline motor operation failed.
2) SOLUTION:
a. Check the connection of the incline motor cable at the MCB.
b. Run auto calibration (See Section 3.5).
c. If auto calibration fails, press GO and attempt to incline the treadmill.
- Check the MCB UP and DOWN (FF) LEDs (Figure A). If the LEDs do not light up when incline is commanded, replace the console
cable or console. If the LEDs do light up, replace the incline motor.
d. If replacing the console, console cable, and incline motor do not resolve the issue, replace the MCB.
FIGURE A
CHAPTER 8: TROUBLESHOOTING

Matrix t3x-03 Specifications

General

Brand	Matrix
Model	t3x-03
Category	Treadmill
Language	English