67
15. Plug in the coax cable, TV power wire, and controller signal wire to the back of the TV (Figure M). NOTE: The yellow RJ45 connector
shown in Figure I is not currently used.
16. Plug in the power adaptor and cord sent with the TV to the base of the treadmill to provide power to the TV (Figure N).
17. Plug in a coax cable to the base of the treadmill (Figure O). NOTE: Matrix does not provide any external coax cables, it is the
responsibility of the club to provide these cables. All coax cables should have a signal strength of 10db.
18. Program the TV using the instructions provided in the Entertainment Owner's Manual (sent with every TV). Test the entertainment keypad
for function.
19. Install the TV back cover (Figure P).
10.4 TV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
FIGURE PFIGURE O
FIGURE NFIGURE M
CHAPTER 10: TREADMILL SPECIFICATIONS AND ASSEMBLY GUIDE
To Next Page
Loading...
Need help?
General
