29
9.3 DECK REPLACEMENT
1) Remove the motor cover as outlined in Section 9.1.
2) Remove the rear roller as outlined in Section 9.2.
3) Remove the four deck screws using a 5 mm Allen wrench (Figure A).
4) Remove the deck from the running belt (Figures B & C).
5) Reverse Steps 1-4 to install a new running deck. note: The running deck is waxed on both sides so the opposite side surface may be
usable. New running deck surfaces must ALWAYS be matched to a new running belt.
6) Tension the running belt as outlined in Section 3.5.
FIGURE A
FIGURE B FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
