Troubleshooting Procedures
CAUTION
!
To avoid electrical shock, personal injury, or death, disconnect power to unit before servicing, unless testing
requires power.
©2005 Maytag Services
16026267 13
1. Incomplete segments.
• Segment missing.
• Partial segment missing.
• Digit flickering (NOTE: Slight flickering is normal.)
2. Colon does not turn on or blink.
3. A distinct change in the brightness of one or more numbers in display.
4. One or more digits in the display are not lighting.
5. Display indicates a number different from one touched, for example, key in 5 and 3 appears in the display.
6. Specific numbers (for example 7 or 9) will not display when key pad is touched.
7. Display does not count down with time blinking or up with clock operation.
8. Display obviously jumps in time while counting down.
9. Display counts down too fast while cooking.
10. Each indicator light does not turn on after setting cooking cycle.
11. Display time of day does not reappear when cooking is finished.
(TROUBLE 1) The following visual conditions indicate a probable failed control circuit.
CONDITION CHECK RESULT CAUSE REMEDY
1. No input can be
programmed.
Continuity
No continuity
Failed P.C.B.
assembly.
Loose
connection.
Replace P.C.B.
assembly.
Connect them
tightly.
Check the conn-
ection between
membrane key
assembly and
P.C.B. assembly.
2. Some inputs
cannot be
programmed.
3. Display shows
a number or
figure different
from one
touched.
4. Random
programming
when touching
other pads.
5. Display is fixed
at some figure
and can not
accept any
input.
Everything works
as specified.
Still have trouble.
Failed key
membrane
assembly.
Failed P.C.B.
assembly.
Replace key
membrane
assembly.
Replace P.C.B.
assembly.
Replace key
membrane
assembly and
check operation.
To Next Page
Loading...
Need help?
General
