©2005 Maytag Services 19 16026267
Disassembly Procedures
To avoid risk of electrical shock, personal injury or death;
disconnect power to oven and discharge capacitor before
following any disassembly procedures.
WARNING
!
Door
panel
Glass
Door
frame
Choke
cover
Choke
cover cap
Handle
Latch
Spring
Lamp Socket Removal
1. Remove outer case, see “Outer Case Removal”
procedure.
2. Remove wire leads from lamp socket terminals.
3. Remove screw securing lamp socket to air duct
assembly.
4. Replace and reassemble in reverse order.
Magnetron Removal
1. Remove outer case, see “Outer Case Removal”
procedure.
2. Disconnect wire leads from the magnetron.
3. Remove screw securing air duct to magnetron.
4. Remove screws securing magnetron to wave guide.
5. Replace and reassemble in reverse order.
NOTE: When removing magnetron, verify dome does
not hit any adjacent parts or damage may occur.
NOTE: When replacing magnetron, verify magnetron
gasket is positioned correctly and in good
condition.
Cooling Fan Removal
1. Remove outer case, see “Outer Case Removal”
procedure.
2. Remove screws securing fan guide assembly to back
cover.
3. Slide fan guide assembly out to gain access to fan
motor.
4. Disconnect wire leads from cooling fan.
5. Remove screws securing fan motor to fan guide
assembly.
6. Replace and reassemble in reverse order.
High Voltage Capacitor and Diode Removal
WARNING
!
To avoid risk of electrical shock, personal injury or
death; discharge capacitor before removing.
1. Remove cooling fan, see “Cooling Fan Removal”
procedure, steps 1 through 3.
2. Disconnect wire leads from capacitor, transformer,
and magnetron.
3. Remove screws securing capacitor bracket and
diode to fan guide assembly.
4. Replace and reassemble in reverse order.
High Voltage Transformer Removal
1. Remove outer case, see “Outer Case Removal”
procedure.
2. Disconnect wire leads from capacitor, transformer,
and magnetron.
3. Remove screws securing transformer to base pan.
4. Lift transformer out from chassis area.
5. Replace and reassemble in reverse order.
Turntable Motor Removal
1. Remove rack, turntable, rotating ring, and turntable
shaft from inside oven cavity.
2. Lay unit on its back to gain access to motor.
3. Remove turntable motor cover from base pan, by
cutting metal connection securing cover.
4. Disconnect wire leads from turntable motor.
5. Remove screws securing motor to oven cavity
assembly.
6. Remove turntable motor.
7. After repairing/replacing motor, rotate cover to fit
metal tabs into slots provided.
8. Use screw provided to secure cover to base pan.
To Next Page
Loading...
Need help?
General
