12
8. Select CYCLE*
Turn cycle knob to select your wash cycle. See “Cycle Guide” for
details on cycle features.
The display will show the default settings for the selected cycle.
To adjust a setting, touch its name – Temperature, Soil Level, or
Spin Speed. Adjusting settings will change the Estimated Cycle
Time. Tightly packing the load, unbalanced loads, or excessive
suds may also cause the washer to increase the cycle time.
9. Adjust settings, if desired*
10. Select any additional options*
To add an option to the cycle, touch its name – Fresh Hold, Steam
for Stains, Extra Rinse, Cycle Signal, or Control Lock. To remove
an option from the selected cycle, touch the option again.
* Not all options and settings are available with all cycles. See “Cycle Guide”
for available options and settings.
USING YOUR WASHER
You can adjust the detergent concentration and water
hardness settings, if needed. Default settings are 2x detergent
concentration and normal water hardness. If the detergent
concentration is not listed on the package, see “About
Detergent Concentration” to calculate the concentration.
To Adjust Dispenser Settings:
1. Touch – or + until the desired concentration appears on the
time display.
2. Touch WATER HARDNESS until the desired water hardness
appears on the time display.
11. Setting detergent concentration and
water hardness
To Next Page
Loading...
Need help?
General