17
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage, or
moving:
1.
Refer to Installation Instructions to locate, level, and
connect washer.
2.
Before using again, run washer through the following
recommended procedure:
To use washer again:
1.
Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
2.
Plug in washer or reconnect power.
3.
Run washer through NORMAL cycle to clean washer and
remove antifreeze, if used. Use only HE detergent. Use half
the manufacturer’s recommended amount for a medium-size
load.
Today’s liquid HE detergents are concentrated. Most brands of
concentrated HE detergent will show the level of concentration on
the bottle. If so, simply set the concentration level in the Optimal
Dispense menu to match the level shown on the bottle.
However, if the detergent bottle does not give the concentration, it
can be easily calculated. Just divide the package size in fluid ounces
by the number of loads. Then refer to the chart below to find the
concentration.
If you do not get your desired cleaning results, try using a lower
concentration number. If you have excess suds, try using a higher
concentration number.
ABOUT DETERGENT CONCENTRATION
Concentration Number of ounces ÷ number of loads
2X 1.5–2.49
3X 0.9–1.49
4X 0.7–0.89
5X 0.5–0.69
6X 0.3–0.49
To Next Page
Loading...
Need help?
General