McIntosh MC202 User Manual

18
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
200 watts into 2 ohm load
200 watts into 4 ohm load
200 watts into 8 ohm load
Power Output Mono
Minimum sine wave continuous average power output per
channel, all channels operating is:
400 watts into 4 ohm load
400 watts into 8 ohm load
400 watts into 16 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 2, 4 or 8 ohm loads (Stereo)
0.005% for 4, 8 or 16 ohm loads (Mono)
Dynamic Headroom
1.9dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
1.7Volt unbalanced inputs
3.4Volt balanced inputs
A-Weighted Signal To Noise Ratio
110dB (1.7V)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 2, 4 or 8 ohm loads (Stereo)
0.005% for 4, 8 or 16 ohm loads (Mono)
Input Impedance
10,000 ohms balanced or unbalanced inputs
Wide Band Damping Factor
Greater than 40
Power Requirements
100 Volts, 50/60Hz at 4.8 amps
110 Volts, 50/60Hz at 4.4 amps
120 Volts, 50/60Hz at 4.0 amps
220 Volts, 50/60Hz at 2.2 amps
230 Volts, 50/60Hz at 2.1 amps
240 Volts, 50/60Hz at 2.0 amps
Note: Refer to the rear panel of the MC202 for the correct
voltage.
Dimensions
Front Panel: 17-1/2 inches (44.45cm) wide, 5-7/16 inches
(13.81cm) high. Depth behind front mounting panel is 18
inches (45.72cm). Clearance required in front of the Front
Panel is 1 inch (2.54cm) for knobs.
Weight
65 pounds (29.49 Kg) net, 83 pounds (37.65 Kg) in ship-
ping carton

McIntosh MC202 Specifications

General

Brand	McIntosh
Model	MC202
Category	Amplifier
Language	English