EasyManuals Logo
Home>McIntosh>Amplifier>MC2102

McIntosh MC2102 User Manual

McIntosh MC2102
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
100 watts into 2 ohm load
100 watts into 4 ohm load
100 watts into 8 ohm load
Power Output Mono Parallel
Minimum sine wave continuous average power output is:
200 watts into 1 ohm, 2 ohm or 4 ohm load
Power Output Mono Bridge
Minimum sine wave continuous average power output is:
200 watts into 4 ohm, 8 ohm or 16 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 70,000Hz
Sensitivity
2.5Volt unbalanced inputs
5.0Volt balanced inputs
A-Weighted Signal To Noise Ratio
100dB
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output does not exceed twice the rated
output, for any combination of frequencies from
20Hz to 20,000Hz is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
Input Impedance
20,000 ohms unbalanced inputs
40,000 ohms balanced inputs
Wide Band Damping Factor
Greater than 18
Power Requirements
100 Volts, 50/60Hz at 6.0 amps
110 Volts, 50/60Hz at 5.5 amps
120 Volts, 50/60Hz at 5.0 amps
220 Volts, 50/60Hz at 2.5 amps
230 Volts, 50/60Hz at 2.5 amps
240 Volts, 50/60Hz at 2.5 amps
Note: Refer to the rear panel of the MC2102 for the correct
voltage.
Tube Compliment
4 - 12AX7A Inputs and Phase Inverters
4 - 12AT7 Voltage Amplifier and Drivers
8 - KT88/6550 Power Output
Dimensions
Front Panel: 17-3/4 inches (45.54cm) wide, 10-1/8 inches
(25.72cm) high. Depth behind front mounting panel is 16
inches (40.64cm). Clearance required in front of the Front
Panel is 1 inch (2.54cm) for knobs.
Weight
88 pounds (40 kg) net, 121 pounds (54.9 kg) in shipping
carton

Other manuals for McIntosh MC2102

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McIntosh MC2102 and is the answer not in the manual?

McIntosh MC2102 Specifications

General IconGeneral
BrandMcIntosh
ModelMC2102
CategoryAmplifier
LanguageEnglish

Related product manuals