EasyManuals Logo
Home>McIntosh>Amplifier>MC7100

McIntosh MC7100 User Manual

McIntosh MC7100
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
PERFORMANCE LIMITS
Performance limits are the maximum
deviation from perfection permitted for a
Mclntosh instrument. We promise you that
when you purchase a new MC7100 from a
Mclntosh Franchised Dealer, it will be
capable of performance at or better than
these limits.
STEREO POWER OUTPUT
150 watts into 4 ohm loads or 100 watts
into 8 ohm loads minimum sine wave con-
tinuous average power output per channel,
both channels operating.
The output RMS voltage is:
28.3V across 8 ohms
24.5V across 4 ohms
MONOPHONIC (BRIDGED)
300 watts into an 8 ohm load minimum
sine wave continuous average power output.
The output RMS voltage is: 49 volts across
8 ohms.
OUTPUT LOAD IMPEDANCE
STEREO
8 or 4 ohms
MONOPHONIC
8 ohms
RATED POWER BAND
20Hz to 20,000Hz
TOTAL HARMONIC DISTORTION
0.005% maximum harmonic distortion at
any power level from 250 milliwatts to rated
power output.
IHF DYNAMIC HEADROOM
8 ohms, 1.7dB
4 ohms, 2.1dB
FREQUENCY RESPONSE
+ 0, -0.25dB from 20Hz to 20.000Hz
+ 0, -3.0dB from 10Hz to 100,000Hz
INPUT SENSITIVITY
1.4 volts (2.5 volts at gain control center
detent)
A-WEIGHTED SIGNAL-TO-NOISE RATIO
95dB (115dB below rated output)
INTERMODULATION DISTORTION. SMPTE
0.005% maximum if instantaneous peak
power output does not exceed twice the out-
put power rating.
RATINGS
WIDE BAND DAMPING FACTOR
8 ohms, 200
4 ohms, 100
INPUT IMPEDANCE
20,000 ohms
POWER GUARD
Clipping is prevented and THD does not
exceed 2% with up to 14dB overdrive at
1000Hz.
POWER REQUIREMENTS
120 volts, 50/60HZ, 3.0 amps UL/CSA
MECHANICAL
SIZE
Front panel: 17 1/2 inches (44.5cm) wide,
by 3 5/8 inches (9.2cm) high.
Chassis: 14 3/4 inches (37.5cm) wide, by
2 3/8 inches (6cm) high, by 14 1/2 inches
(36.9cm) deep, (from back of front panel), in-
cluding connectors. Panel clearance re-
quired in front of the mounting surface is 1
inch (2.54cm).
FINISH
Glass with special gold/teal nomenclature
illumination. Chassis and chassis cover are
black.
WEIGHT
24 pounds (11 Kg) net; 35 pounds (15.9Kg)
in shipping carton.
SPECIFICATIONS
11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McIntosh MC7100 and is the answer not in the manual?

McIntosh MC7100 Specifications

General IconGeneral
BrandMcIntosh
ModelMC7100
CategoryAmplifier
LanguageEnglish

Related product manuals