52
InstallationInstallation
Preliminary Site Survey
Electrical supply and installation is to conform to local authority's codes and regulations. (e.g. National Electricity Board).
Voltage supply fluctuation must not exceed +/- 10% of rated voltage. Electricity supply lines must be independent of
welding transformers which can cause high supply fluctuation. Ensure that the location is convenient for wiring and
piping.
Installation Of Indoor Unit
The indoor unit must be installed such that there is no short circuit of the cool discharge. Comply to the installation
clearance recommended. Do not put the indoor unit where there is direct sunlight on unit. Make sure the location is
suitable for piping and drainage. Precautions steps :
i) Use the hanger supplied with the unit.
ii) Ensure the support is strong enough to withstand the weight of the unit.
iii) Use the supplied drain socket to connect the drain pipe.
The diagrams below show the screws position for duct work connection.
Install the unit in such a way
that the condensate water can
flow out smoothly.
To Next Page
Loading...
Need help?
General
