63
EN
HR
SI
IT
If the brushes bend, it may help to place the brushes in hot water to
encourage them to return to their original shape.
8.4. Cleaning the front wheel
If the front wheel is blocked, remove the wheel and clean the dirt from it using a
damp cloth.
Reinsert the front wheel until it clicks into place.
9. Troubleshooting
If the appliance stops working properly, please refer to the troubleshooting table
shown below to see if you can resolve the problem yourself.
Never attempt to repair the appliance yourself. If a repair is necessary, please
contact our Service Centre or a suitable authorised repair workshop.
Problem Possible cause Solution
The appliance cannot
be switched on.
The battery block is
flat.
Leave the battery block
to charge fully for approx.
4.5 hours.
Operating light on the
robot vacuum cleaner
is flashing after the
appliance has been
switched on.
The battery block is
flat.
Leave the battery block
to charge fully for approx.
4.5 hours.
Clear all faults
Robot vacuum cleaner
does not move.
Single acoustic signal
sounds.
Wheels are blocked.
Remedy the fault on the
wheels.
To Next Page
Loading...
Need help?
General
