58
NOTICE!
Possible material damage!
For reasons of design within a room, it may be possible
that the sensors of the robot vacuum cleaner do not
fully detect stairs and obstacles. There is the risk of
creating blind spots with which the robot can fall down
stairs.
Test in operation whether or not the robot vacuum
cleaner detects stairs or other obstacles.
If necessary, set up additional barriers to prevent
damage to objects, walls, stairs or the appliance.
7.1. Setting the start time
To start a cleaning process in your absence, set a start time for the cleaning. Proceed
as follows:
Move the On/Off switch to the I position and the appliance is ready for use.
Press the button to set the start time.
The hour display flashes.
Use arrow button or to set the hour. Then press the button to set the
minutes display in 15 minute increments.
The minute display flashes.
Use arrow button or to set the minutes.
Confirm your selection by pressing the button.
During programming, the remote control must be held up to the
appliance. The subsequent acoustic signal indicates that the robot
vacuum cleaner has received and confirmed the data.
The start time has now been set. The LED operating lights on the robot vacuum
cleaner flash. The cleaning process starts at the set time.
To deactivate the start time, set the start time to 00:00.
7.2. Selecting the mode
The robot vacuum cleaner is automatically guided through the room via the sensors
and bumpers on the appliance. You can select how the robot vacuum cleaner
should operate:
To Next Page
Loading...
Need help?
General
