68
Garage Door Opener
1. Remote control transmitter
located on inside rear view
mirror
2. Portable remote control
transmitter
Warning!
When programming a garage door
opener, the door moves up or
down.
When programming or operating the
remote control make sure there is no
possibility of anyone being harmed
by the moving door.
The built-in remote control is capable
of operating up to three separately
controlled objects.
Notes:
Certain types of garage door openers
are incompatible with the integrated
opener, if you should experience
difficulties with programming the
transmitter, contact your authorized
Mercedes-Benz dealer or call
Mercedes-Benz Customer Assistance
Center (in the U.S.A. only) at 1-800-
FOR-MERCedes.
For operation in the USA only: This
devise complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause
harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
Any unauthorized modification to this
device could void the user's authority
to operate the equipment.
Programming or reprogramming the
remote control:
1. Turn key in steering lock to
position 1 or 2.
2. Press and hold one button of
the remote control located on
the inside rear view mirror until
its control light begins to flash at
a rate of about once a second.
Continue holding down the
button.
Note:
The light blinks immediately if the
remote control is being
programmed for the first time, or if
its memory was previously erased.
If you are reprogramming a
previously used button, the fight
will flash after about 20 seconds.
To Next Page
Loading...
Need help?
General
