55
Getting started
Driving
Wiping with windshield washer fluid
왘 Press the combination switch in direc-
tion of arrow 1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
컄 page 329).
i
To prevent smears on the windshield,
wipe with windshield washer fluid every
now and then even when it is raining.
!
If anything blocks the windshield
wipers (leaves, snow, etc.), switch
them off immediately.
앫 For safety reasons, stop the vehicle
in a safe location and,
앫 remove SmartKey from starter
switch
or
앫 turn off the engine by pressing
the KEYLESS-GO* start/stop
button and open the driver’s
door (with the driver’s door
open, starter switch is in posi-
tion 0, same as with SmartKey
removed from starter switch)
before attempting to remove any
blockage.
앫 Remove blockage.
앫 Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in combination switch position I,
앫 set the combination switch to the
next higher wiper speed
앫 have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center.
To Next Page
Loading...
Need help?
General
