EasyManuals Logo

Mercedes-Benz C-Class 2018 User Manual

Mercedes-Benz C-Class 2018
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #359 background imageLoading...
Page #359 background image
X
Clean the wheel and wheel hub contact sur-
faces.
X
Slide the wheel to be mounted onto the align-
ment bolt and push it on.
X
Tighten the wheel bolts until they are finger-
tight.
X
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
tight.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
X
Turn the crank of the jack counter-clockwise
until the vehicle is once again standing firmly
on the ground.
X
Place the jack to one side.
X
Tighten the wheel bolts evenly in a crosswise
pattern in the sequence indicated (: to A).
The tightening torque must be 111 lb-ft
(150 Nm).
X
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle tools
in the trunk again.
X
Mercedes-AMG vehicles and vehicles
with AMG equipment: insert the cover into
the outer sill.
X
Check the tire pressure of the newly mounted
wheel and adjust it if necessary.
Observe the recommended tire pressure
(
Y page 336).
When you are driving with the collapsible spare
wheel mounted, the tire pressure loss warning
system or the tire pressure monitor cannot func-
tion reliably. Only restart the tire pressure loss
warning system or tire pressure monitor when
the defective wheel has been replaced with a
new wheel.
Vehicles with a tire pressure control sys-
tem: all installed wheels must be equipped with
functioning sensors.
Wheel/tire combination
You can ask for information regarding permitted
wheel/tire combinations at an authorized
Mercedes-Benz Center.
!
For safety reasons, Mercedes-Benz recom-
mends that you only use tires and wheels
which have been approved by Mercedes-Benz
specifically for your vehicle.
These tires have been specially adapted for
use with the control systems, such as ABS or
ESP
®
, and are marked as follows:
R
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
(tires featuring run-flat characteristics)
R
MO1 = Mercedes-Benz Original (only cer-
tain AMG tires)
Mercedes-Benz Original Extended tires may
only be used on wheels that have been spe-
cifically approved by Mercedes-Benz.
Only use tires, wheels or accessories tested
and approved by Mercedes-Benz. Certain
characteristics, e.g. handling, vehicle noise
emissions or fuel consumption, may other-
wise be adversely affected. In addition, when
driving with a load, tire dimension variations
could cause the tires to come into contact
Wheel/tire combination
357
Wheels and tires
Z

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercedes-Benz C-Class 2018 and is the answer not in the manual?

Mercedes-Benz C-Class 2018 Specifications

General IconGeneral
BrandMercedes-Benz
ModelC-Class 2018
CategoryAutomobile
LanguageEnglish

Related product manuals