Adaptive Highbeam Assist automatically
switches between the following types of light:
R
Low beam
R
High beam
At speeds greater than 19 mph (30 km/h):
R
If no other road users are detected, the high
beam will switch on automatically.
The high beam will switch off automatically in
the following cases:
R
At speeds below 16 mph (25 km/h)
R
If other road users are detected
R
If street lighting is sufficient
%
The system's optical sensor is located
behind the windshield near the overhead
control panel.
Switching Adaptive Highbeam Assist on/off
Switching on
#
Turn the light switch to the à position.
#
Switch on the high beam using the combina‐
tion switch.
If Adaptive Highbeam Assist is activated,
the _ indicator lamp will light up on the
multifunction display.
Switching off
#
Switch off the high beam using the combina‐
tion switch.
Switching the daytime running lamps on/off
Multimedia system:
4
Vehicle
5
÷ Light Settings
5
Daytime Run. Lights
#
Activate O or deactivate ª the function.
Setting the exterior lighting switch-off delay
time
Multimedia system:
4
Vehicle
5
÷ Light Settings
5
Ext. Light Switch Off
#
Set the switch-off delay time.
Setting the surround lighting
Multimedia system:
4
Vehicle
5
÷ Light Settings
5
Locator Lighting
#
Activate O or deactivate ª the function.
If the surround lighting is switched on, the exte‐
rior lighting remains lit for 40 seconds after the
112
Light and visibility
To Next Page
Loading...
Need help?
General
