1
Rear fenders
Use Technical Specification ISO/TS 21609 (Road
Vehicles – "EMCs for installation of aftermarket
radio frequency transmitting equipment") when
retrofitting two-way radios. Comply with the
legal requirements for detachable parts.
If your vehicle has installations for two-way radio
equipment, use the power supply and antenna
connectors provided in the pre-installation.
Observe the manufacturer's supplements when
installing.
Two-way radio transmission output
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the values
in the following table.
Frequency band and maximum transmission
output
Frequency band Maximum transmis‐
sion output
Short wave
3 - 54 MHz
(30 W)
4 m frequency band
74 - 88 MHz
(15 W)
2 m frequency band
144 - 174 MHz
(25 W)
trunked radio sys‐
tem/Tetra
380 - 460 MHz
(10 W)
Frequency band Maximum transmis‐
sion output
70 cm frequency
band
420 - 450 MHz
(15 W)
Two-way radio
(2G/3G/4G)
(10 W)
The following devices can be used in the vehicle
without restrictions:
R
Two-way radios with a maximum transmis‐
sion output of up to 100 mW
R
Two-way radios with transmitter frequencies
in the 380 - 410 MHz frequency band and a
maximum transmission output of up to 2 W
(trunked radio system/Tetra)
R
Mobile phones (2G/3G/4G)
There are no restrictions when positioning the
antenna on the outside of the vehicle for the fol‐
lowing frequency bands:
R
Trunked radio system/Tetra
R
70 cm frequency band
386
Technical data
To Next Page
Loading...
Need help?
General
