CPM-QE/ RCM
HARMAN BECKER AUTOMOTIVE SYSTEMS GMBH 2018-05-30 16:03:00
CONFIDENTIAL / ALL RIGHTS RESERVED Regulatory Compliance Management
Manual Hermes page 10 of 18
3.1.4 Diagnosis
The Maincontroller of the HERMES is realised by a Renesas SH726B with 216MHz, 2MB Flash and
1,25MB RAM. In the following blockdiagram you can see the diagnosis ports from ant to the SH2
system controller.
3.1.4.1 Hermes
3.1.5 Operating States
The following picture shows the possible HERMES operating states – these are:
Full Sleep mode, Normal Power mode and DNO mode
3.1.6 HW-clocking table
Device Clock
NAD (Application Processor) 666MHz
SH2 (CAN Controller) 216MHz
RL78 (WakeUp Controller) 32MHz
To Next Page
Loading...
Need help?
General
