MAINTENANCE
101
NOTE: The outboard can be tilted or in the vertical operating
position during flushing.
1. With the engine turned off, place the outboard in either the
operating position (vertical) or in a tilted position.
2. Remove the flush connector from the bottom cowl.
3. Recover the cover from the flush connector and thread a water
hose into the flush connector.
4. Turn on the water tap (1/2 maximum) and let the water flush
through the cooling system for about 15 minutes.
5. When flushing is complete, turn off water and disconnect the
water hose.
6. Reinstall the cover on the flush connector. Place the flush
connector back into the bottom cowl.
Top Cowl Removal and Installation
TOP COWL REMOVAL
1. Unlock the top cowl by pushing down on the latch catch and
pull up the cowl lock latch.
To Next Page
Loading...
Need help?
General
