MAINTENANCE
114
IMPORTANT: Visually inspect for fuel leakage from the filter while
turning the ignition key to the run position, forcing fuel into the
filter.
ob01258
Corrosion Control Anode
The outboard has corrosion control anodes at different locations.
An anode helps protect the outboard against galvanic corrosion by
sacrificing its metal to be slowly eroded instead of the outboard
metals.
Each anode requires periodic inspection, especially in salt water
which will accelerate the erosion. To maintain this corrosion
protection, always replace the anode before it is completely
eroded. Never paint or apply a protective coating on the anode as
this will reduce effectiveness of the anode.
Two anodes are located on each side of the gearcase. Another
anode is installed on the bottom of the pedestal. Two more anodes
are located on the bottom of each power trim ram.
ob01515
To Next Page
Loading...
Need help?
General
