EasyManuals Logo
Home>Mercury>Automobile>2008 Sable

Mercury 2008 Sable User Manual

Mercury 2008 Sable
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #246 background imageLoading...
Page #246 background image
HAZARD FLASHER CONTROL
The hazard flasher is located on the
instrument panel by the radio. The
hazard flashers will operate when
the ignition is in any position or if
the key is not in the ignition.
Push in the flasher control and all
front and rear direction signals will flash. Press the flasher control again
to turn them off. Use it when your vehicle is disabled and is creating a
safety hazard for other motorists.
Note: With extended use, the flasher may run down your battery.
FUEL PUMP SHUT-OFF SWITCH
This device stops the electric fuel pump from sending fuel to the engine
when your vehicle has had a substantial jolt.
After an accident, if the engine cranks but does not start, this switch
may have been activated.
The fuel pump shut-off switch is
located in the front passenger
footwell area in the right upper
corner.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.
4. Turn the ignition ON.
5. Wait a few seconds and return
the key to OFF.
6. Make another check for leaks.
2008 Sable (mgo)
Owners Guide (post-2002-fmt)
USA (fus)
Roadside Emergencies
246

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 2008 Sable and is the answer not in the manual?

Mercury 2008 Sable Specifications

General IconGeneral
BrandMercury
Model2008 Sable
CategoryAutomobile
LanguageEnglish

Related product manuals