Section 4 - Maintenance
90-8M0113857 eng DECEMBER 2015 Page 41
NOTE: Oil capacities include the gear lube monitor.
Model Capacity Fluid Type
Bravo One 2736 ml (92‑1/2 oz)
High Performance Gear Lubricant
Bravo Two 3209 ml (108‑1/2 oz)
Bravo Three (single seawater pickup) 2972 ml (100‑1/2 oz)
Bravo Three (dual seawater pickup) 2736 ml (92‑1/2 oz)
13. Remove the pump from the oil fill and drain hole. Quickly install the sealing washer and screw. Tighten securely.
14.
Reinstall the propeller. Refer to Propellers.
15. Check the oil level after the first use.
IMPORTANT: Oil level in the gear lube monitor rises and falls during operation. Always check the oil level when the sterndrive
is cool and the engine is off.
Power Trim Fluid
Checking
IMPORTANT: Check the oil level with the sterndrive unit in the full down/in position only.
1. Place the sterndrive unit in full down/in position.
2. Remove the fill cap from the reservoir.
a - Fill cap
b - Reservoir fill neck
c - "MIN" and "MAX" lines
3. Observe the oil level. Level must be between the "MIN" and "MAX" lines on the reservoir.
NOTE: Fill cap is vented.
4. Fill as necessary with the specified fluid.
Tube Ref No.
Description Where Used Part No.
114
Power Trim and Steering Fluid Power trim pump 92-858074K01
Filling
1. Remove the fill cap from the reservoir.
2. Add lubricant to bring level to the bottom of the filler neck.
Tube Ref No.
Description Where Used Part No.
114
Power Trim and Steering Fluid Power trim pump 92-858074K01
3. Install the cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris. Contact your authorized
Mercury MerCruiser dealer.
b
c
a
5573
To Next Page
Loading...
Need help?
General