OPERATION
41
ob00331
IMPORTANT: If no water is coming out of the water pump indicator hole, stop engine and check cooling water
intake for obstruction. No obstruction may indicate a water pump failure or blockage in the cooling system. These
conditions will cause the engine to overheat. Have the outboard checked by your dealer. Operating the engine
while overheated may cause serious engine damage.
WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for 3 minutes.
Gear Shifting
IMPORTANT: Observe the following:
• Never shift outboard into gear unless engine speed is at idle.
• Do not shift outboard into reverse when the engine is not running.
• Your outboard has three gear shift positions to provide operation: Forward (F), Neutral (out of gear), and
Reverse (R).
F N RF N R
ob00358
• Remote Control Models ‑ When shifting, always stop at neutral position and allow the engine speed to return
to idle.
ob00308
• Tiller Handle Models ‑ Reduce engine speed to idle before shifting.
START
ob00359
• Always shift outboard into gear with a quick motion.
To Next Page
Loading...
Need help?
General
