MAINTENANCE
74
3. Start the engine and run it at idle speed in neutral shift position.
IMPORTANT: Do not run engine above idle when flushing.
4. Adjust water flow (if necessary) so excess water continues
leaking out from around the rubber cups to ensure the engine
is receiving an adequate supply of cooling water.
5. Check for a steady stream of water flowing out of the water
pump indicator hole. Continue flushing the outboard for 3 to 5
minutes, carefully monitoring water supply at all times.
6. Stop the engine, turn off the water, and remove the flushing
attachment. Reinstall the propeller.
Exterior Care
Your outboard is protected with a durable baked enamel finish.
Clean and wax often using marine cleaners and waxes.
Top Cowl Removal and Installation
REMOVAL
1. Release the front and rear cowl latches.
2. Lift the top cowl from the outboard.
3110
INSTALLATION
1. Position the top cowl over the engine.
To Next Page
Loading...
Need help?
General
